TMR feed mixer adds the materials to be mixed through the lower feed port, and the lifting screw inside the feed mixer sends the mixing materials from the feed hopper of the stand mixer into the vertical screw conveyor. After it is lifted upward to the top, it is then thrown in the umbrella shape to fall around the mixing cylinder and re-enter the vertical screw conveyor through the gap at the bottom of the sleeve, and then lifted upward again. In this way, stir and mix until the mixture is uniform. Then open the discharge port and unload the material.
Too much scale of cooling system, serious blockage of waterways, resulting in poor heat dissipation of the body. Diesel engines used for a long time are prone to the phenomenon that the cylinder and radiator scale is too thick, resulting in poor heat dissipation of diesel engines. Elimination method: chemical cleaning of cylinder block and radiator. Common chemical cleaning solutions are 8% caustic soda solution, 10% sodium carbonate solution and 2.5% hydrochloric acid solution. When the first two kinds of cleaning liquid are used, the solution should be retained in the cooling system for 10 to 12 hours; When the third cleaning solution is used, the engine should be started immediately after injection and run for 1 hour at a low speed without load. During the cleaning process, the thermostat should be removed; After the discharge of the cleaning liquid, the water discharge switch should be unloaded in time to remove dirt, and then flush the water jacket and radiator of the engine with clean water according to the countercurrent method until the outflow of water is all clean; When flushing, the water pressure should be controlled within 30kpa.
In order to ensure that the feed mill equipment operators carry out daily maintenance, it is required that the operators carry out feed mill equipment maintenance before the end of each shift and a certain period of time before festivals and holidays. For the feed crusher equipment that can not be stopped for maintenance during continuous operation, take time to wipe, check and maintain, complete the work content specified in the maintenance rules and meet the requirements.
Feed crusher equipment inside and outside clean, no rust, clean and tidy work site, ground without oil, garbage; The workpiece is stored neatly. All transmission systems work normally; All operating handles are flexible and reliable. Complete lubrication device, keep properly, clean. The protective device is complete, reliable and clean inside and outside.
Cattle Tmr Feed Mixder from HINDA
If you need a New TMR Feed Mixer, contact the experts at HINDA International today. Our machines are designed to be used for large, medium, and small cattle farms，got farms. Contact Us by email for more information about our Products and how they can help your operation