After using the feed mixer for a period of time, some users found that the feeding speed of the equipment was not as fast as at the beginning, and there was a phenomenon of slowing down or even no feeding, which we made the following analysis and summary:
1. Fast feeding leads to fast feeding; Open the blocked tuyere and reduce the feeding speed.
2. Most of the time, the motor on the feed mixer is broken, but it is still spinning, seemingly without any malfunction, but in fact it is not fast enough to crush the corn. At this time how to do, teach you a trick to start the feed mixer, do not pour corn into the pit, put your hand on the mouth of the feed, feel the suction of the wind, under normal conditions can suck up the palm, if not meet this condition, only slight wind, then the electric machine will be damaged, need to be repaired or replaced. I would like to remind you that this method must be self-priming and safe.
3, hammer wear serious. Remove the pin that fixes the hammer, turn it around, wear the surface through the shaft, and fix it again with the pin (Note: each group of hammer is verified by the manufacturer, it is recommended not to change the grouping of hammer, turn the hammer of each group! Otherwise the crusher will vibrate.
4. The height between the feeding port and the ground is not appropriate. If it is too high, the feed pipe will not gather wind and will not feed. If it's too low, it won't be able to feed much, which affects efficiency. Therefore, you can try more ways to know how high the feed port is above the ground. Try it a few times. Practice is more practical than theory.
The above is the introduction of the reason why the feed mixer does not feed. Do you understand it? If you want to know more about the blender, please pay attention to our website, wonderful content at any time to show you!