The spreader is to feed a large amount of feed to cattle and sheep at one time, quickly and conveniently. Before starting the device, check and adjust the device to ensure that the device runs safely. So today we need to know is the pre-boot check and adjustment.
1. Check whether the screws at each joint of the machine are loose, deformed or damaged, and parts are lost. If necessary, repair or replace them; The ground should be level and the tires should be flat.
2. Check whether the brake of the spreader is effective and whether the clutch plate can work normally.
3. According to the operation instructions of the equipment, master the feeding amount used, which will inevitably overload and affect the feeding effect. Usually the loading volume accounts for 60-75% of the total volume;
4. According to the feed water content control machine feed quantity;
5. In the process of adding, prevent iron, stone, packaging rope and other sundries from mixing with the equipment, causing damage to the unit.
It is very necessary to check the spreader before starting up. If the problem is found before use, some problems can be avoided during operation, and we do not have to waste time to solve the problem or maintain the equipment; If you do not check before starting, it is likely that there will be problems when you just operate. If precautions are not taken properly, the operation will be greatly delayed, wasting resources and time.