Daily maintenance of feed mixer is the primary premise to ensure production safety and work efficiency, so we need to do the following specifications:
1. Power supply, switch and wire should be reliably insulated and easily controlled. Do not use fuses or fuses that do not conform to the rated current of the supporting motor of the unit.
2, check the tension of each belt (the motor can move left and right, the AB impeller can move back and forth) to make it fit.
3, check the connecting parts, bolts are loose, manual propeller shaft, check whether there is a phenomenon of stuck material, whether the propulsion force is flexible, whether the hammer of the crusher rotor is flexible and reliable.
4. Check whether the connecting parts of the feed pipe and mixer leak powder. In the observation hole, check whether there are sundries in the main hopper and propeller. If not, it can be used normally.
5. Check the connecting parts, whether the bolts are loose, the manual propeller shaft, check whether there is a phenomenon of jammed collision and whether the propulsion is flexible, whether the crusher rotor hammer is flexible and reliable.
6. Check whether there is material leakage in each connecting part of the equipment, observe whether there is debris in the silo, if not, it is normal.
7, power supply, switch and wire must be insulated and easy to control. Do not use fuses or fuses that do not match the rated current of the motor supporting the unit. The motor with more than 4.5KW needs to be equipped with overload protection device.
8. A machine warehouse for preparing feed is a batch. Weigh the materials needed for the feed mix. First start the stirring motor, then start the crushing motor (otherwise the impeller will be blocked and the motor will be burned), input the material that does not need to be broken from the auxiliary hopper, add the material that will be broken to the crusher, and carry out on both sides at the same time until the processing of main and auxiliary materials is completed. When done, continue stirring for 5-10 minutes to complete a cycle. After bagging the finished product, it is ready for the next batch of production. Note: Add small amounts of ingredients need to be gradually expanded.
9. Check the rotation direction of the motor. The motor should rotate in the direction specified by the arrow on the sign, otherwise it may damage the machine.
The above is a summary of all the daily maintenance specifications of feed mixers. It is not necessary for you to fully grasp, just need to find out the problems of your own feed mixer and improve it according to your actual situation