After the work of the feed mixer is completed, it is necessary to clean the external dirt, clean the concentrate feed and debris in the working organization, and clean it with water or oil if necessary. Need to wipe after oil, sticker recommended to reduce the chance of oxidation with air contact.
Complex high-precision equipment is recommended to be placed in the shade, dry, natural ventilation indoor storage; For the stranded dragon, feeder and other simple equipment, can also be stored in the open air, but to be placed in a higher, dry, not sunlight position, it is recommended to build a shelter to cover; Where the parts and accessories in direct contact with the ground, should be supported with wood or brick; The falling protective paint should be reapplied.
The spring, transmission belt, rod, tire and other parts of the feed mixer will produce plastic deformation due to long-term stress or improper placement. Therefore, it should be properly supported under the frame so that the tire is not under load and all compressed or opened springs on the feed mixer should be relaxed.
Remove the drive belt and keep it indoors. Some parts that are easy to deform, such as rods, should be suspended flat or vertically. In addition, the removed part, such as the seed pipe, is retained to prevent extrusion deformation. For the feed mixer parked for a long time, a registration card should be established to record the technical status, auxiliary devices, spare parts and tools of the machine and tools in detail. All kinds of machines and tools should be kept by specially-assigned persons, and it is strictly prohibited to disassemble the parts for other purposes. If there is no warehouse, when the machine is parked outside, the motor, transmission belt and other easy to lose parts should be taken out and marked, stored indoors.
I believe that we have a new understanding of the feed mixer shutdown maintenance work, hope to help you!